Cisco Cisco Email Security Appliance C160 テクニカルリファレンス
![Cisco](https://files.manualsbrain.com/attachments/7380d0050044647c30f5c24bbbf5d0c0b6d9bb84/common/fit/150/50/faa183d287233c52228cfea3dbc2a127fe780f60564fcb0955d9c3d1cd23/brand_logo.png)
3-22
CLI Reference Guide for AsyncOS 9.6 for Cisco Email Security Appliances
Chapter 3 The Commands: Reference Examples
Configuration File Management
loadconfig
Description
Load a configuration file.
Note
Loading configuration on clustered machines is supported only using GUI. For instructions, see User
Guide for AsyncOS for Cisco Email Security Appliances.
Guide for AsyncOS for Cisco Email Security Appliances.
Usage
Commit: This command requires a ‘commit’.
Cluster Management: This command can be used in all three machine modes (cluster, group, machine).
Batch Command: This command does not support a batch format
Example
In this example, a new configuration file is imported from a local location.
mail3.example.com> loadconfig
1. Paste via CLI
2. Load from file
[1]> 2
Enter the name of the file to import:
[]> changed.config.xml
Values have been loaded.
Be sure to run "commit" to make these settings active.
mail3.example.com> commit
Please enter some comments describing your changes:
[]> loaded new configuration file
Do you want to save the current configuration for rollback? [Y]> n
Changes committed: Fri May 23 11:42:12 2014 GMT
In this example, a new configuration file is pasted directly at the command line. (Remember to type
Control-D on a blank line to end the paste command.) Then, the system setup wizard is used to change
the default hostname, IP address, and default gateway information. Finally, the changes are committed.
Control-D on a blank line to end the paste command.) Then, the system setup wizard is used to change
the default hostname, IP address, and default gateway information. Finally, the changes are committed.
mail3.example.com> loadconfig
1. Paste via CLI
2. Load from file
[1]> 1
Paste the configuration file now.
Press CTRL-D on a blank line when done.
[The configuration file is pasted until the end tag </config>. Control-D is entered on a
separate line.]
Values have been loaded.
Be sure to run "commit" to make these settings active.