Cisco Cisco Email Security Appliance C190 インストールガイド

For more information, see 

 for an illustration of the port in the Cisco S170 

model appliance. 

Connect one RJ-45 connector to the management interface port. 

Connect the other end of the Ethernet cable to the management port on your computer and make 
sure that your computer is configured to obtain an IP address using DHCP. 

Console port—for use with the CLI.

Connect the serial console cable. The console cable has a DB-9 connector on one end for the 
serial port on your computer and the other end is an RJ-45 connector.

Connect the RJ-45 connector to the Console port on the Cisco 170 series appliance. 

Connect the other end of the cable, the DB-9 connector, to the console port on your computer.

Ethernet ports—direct connection.

Connect the RJ-45 connector to the Ethernet port.

Connect the other end of the Ethernet cable to your network device, such as a router, switch, or 
hub.

Connect the power cord to the Cisco 170 series appliance and connect the other end to your power 
source. 

Power on the appliance.

Check the Power LED on the front of the Cisco 170 series appliance. When it is solid green, the 
appliance is powered on.

For additional information on installation and post-installation tasks, see the following Hardware Quick 
Start Guides: 

Cisco C170 Email Security Appliance Quick Start Guide: 

Cisco M170 Content Security Management Appliance Quick Start Guide: 

Cisco S170 Web Security Appliance Quick Start Guide: