Cisco Cisco Email Security Appliance X1070 リリースノート

Release Notes for Version 2 of the RAID Diagnostic Tool for Cisco Email Security, Web Security, and Content Security Management Appliances

Applicable Hardware

Caution

Before running the RAID Diagnostic Tool, review the

Known Caveats, page 2

Applicable Hardware

This tool is intended for use only with 80-series hardware.

Known Caveats

•

In some cases, when you run the RAID Diagnostic Tool for the first time, the SuperCap version may
not be displayed. The following sample shows the message displayed by the tool:

----------------------------- CAUTION ---------------------------------------

| |

| The Supercap version of this host could not be obtained. |

| |

| Additional action will be required to get the Supercap part number |

| |

| - First reboot the appliance and run the upgrade again. |

| |

------------------------------------------------------------------------------

In this scenario, restart the appliance and run the RAID Diagnostic Tool again. After rebooting your
appliance, if you encounter one of the following situations, contact Cisco TAC:

–

If the SuperCap version is not displayed after rerunning the tool.

–

If the SuperCap version is 49571-13A or 49571-15C. In this case, you need to request Cisco
TAC to replace your appliance.

•

The RAID Diagnostic Tool will be listed on the System Upgrade page of the web interface.
However, you cannot run this tool on the web interface.

Examples

•

Running the RAID Diagnostic Tool on Content Security Management Appliances, page 2

•

Running the RAID Diagnostic Tool on Email Security Appliances, page 3

•

Running the RAID Diagnostic Tool on Web Security Appliances, page 4

Running the RAID Diagnostic Tool on Content Security Management
Appliances

sma.example.com> upgrade

Choose the operation you want to perform:

- DOWNLOADINSTALL - Downloads and installs the upgrade image (needs reboot).

- DOWNLOAD - Downloads the upgrade image.

[]> downloadinstall

Upgrades available.