Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch メンテナンスマニュアル

System Logs

Cisco Small Business SF200E Series Advanced Smart Switch

60

 

•

Informational—Device information.

•

Debug—Provides detailed information about an event.

 When you select a severity level, any events of that level or higher are 

automatically selected for logging.

Click Apply. Your changes are saved to the Running Configuration.

You can define one or more remote log servers that the switch sends Syslog 
messages to. Use the Remote Log Servers page to define log servers and to set 
the severity level of the log events to be sent to the server. 

To enable Syslog operation and configure a remote log servers:

Click Administration > Remote Log Servers in the navigation window.

For the Syslog Logging mode, click Enable, and then configure the following 
settings:

•

Facility—Select a value from the list that identifies the classification of 
syslog messages from this switch. The meaning of these values (Local 0 
through Local 7) is determined by the network administrator.

•

Local Port—Specify the IANA port number for the switch. The default is the 
well-known port number for the Syslog protocol, 514.

Click Apply.

In the Remote Log Server Table, click Add.

Enter the parameters:

•

Log Server—IPv4 address or hostname of the server to send logs to.

•

UDP Port—The logical UDP port number the remote server uses for the 
Syslog protocol. The default value is the well-known IANA Syslog port 
number, 514.

•

Minimum Severity—Only items that meet or exceed this severity level are 
sent to the remote server. See 

 for a description of 

the severity levels.