Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
16
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62
Release Notes
STEP 1
Open the Administration > Routing Resources page.
STEP 2
Adjust the IPv6 entry from the default value to 8, then apply and reboot the switch
to take effect.
to take effect.
STEP 3
After the switch boots up, configure IPv4 entry to 1800, then apply and reboot.
STEP 4
The backup switch will reboot repeatedly, other stack members work as
expected.
expected.
Solution:
Adjust the IPv4 and IPv6 router resources at the same time. To recover
the backup switch, you need to press the reset button for 10 seconds to return it to
factory defaults.
factory defaults.
Japanese language files and firmware version compatibility
guideline
guideline
Users will see a mismatch in the features between the English language and the
Japanese language when running certain combinations of firmware and language
files. Users will see new features added since version 1.1.1.6 in English instead of
Japanese in the GUI when running firmware version 1.1.2.0 and higher subject to
the following restriction:
Japanese language when running certain combinations of firmware and language
files. Users will see new features added since version 1.1.1.6 in English instead of
Japanese in the GUI when running firmware version 1.1.2.0 and higher subject to
the following restriction:
•
Japanese language files version 1.1.1.6 and older are forward compatible up
to Firmware version 1.1.2.0. For example: loading a version 1.1.1.6 language
file onto a device running firmware version 1.2.7.76 and up will fail.
to Firmware version 1.1.2.0. For example: loading a version 1.1.1.6 language
file onto a device running firmware version 1.2.7.76 and up will fail.
•
Japanese language files version 1.1.1.10 and newer are only compatible with
firmware version 1.2.7.76 and newer.
firmware version 1.2.7.76 and newer.