Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62

Release Notes

Limitations and Restrictions

The following caveats are acknowledged in release 1.3.0.62:

Problem:

In switch mode although multiple default gateways can be configured

through CLI, only the gateway with lowest value can be active. Hence, switches
should not allow the CLI to configure multiple default gateways.

Solution:

When modifying the default gateway through CLI, delete the old one

first. (CQ147302)

Problem:

In web GUI “Security->Arp Inspecties->Properties”, the “DHCP

Snooping Binding database” hyperlink is invalid.

Solution:

Access it through “IP Configuration-> DHCP-> DHCP Snooping Binding

Database”. (CQ147363)

Problem:

When the firmware is downgraded from 1.3.0.62 to 1.2.9.44, the IP static

routes are lost.

Solution:

Configure static route again after downgrade to previous release.

(CQ147578)

Problem:

When the value of the SA or DA is changed from a valid MAC to any

other value in the webpage, the SA or DA becomes 0000.0000.0000 in CLI.

Solution:

Delete ACL and configure again. (CQ147665)

Problem:

In web GUI “Security->IP Source Guard->Properties”, the “DHCP

Snooping” hyperlink is invalid.

Solution:

Access it through “P Configuration-> DHCP Snooping/Relay”.

(CQ147666)

Problem:

In web GUI “Security->IP Source Guard->Interface”, the “DHCP

Snooping” and “DHCP Snooping untrusted interfaces” hyperlinks are invalid.

Solution:

Access them through “IP Configuration-> DHCP Snooping/Relay”.

(CQ147667)