Cisco Cisco Packet Data Gateway (PDG) トラブルシューティングガイド
IPv6 ACL Configuration Mode Commands
▀ deny/permit (by TCP/UDP packets)
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
Specifies that all destination TCP port numbers greater than the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all destination TCP port numbers less than the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Specifies that all destination TCP port numbers not equal to the one specified are to be filtered.
must be configured to any integer value from 0 to 65535.
Usage
Block IP packets when the source and destination are of interest but for only a limited set of ports.
Important:
The maximum number of rules that can be configured per ACL varies depending on how the ACL is
to be used. Refer to the Engineering Rules appendix located in the Administration and Configuration Guide for more
information.
information.