Cisco Cisco Packet Data Gateway (PDG) トラブルシューティングガイド

ページ / 5302
  Subscriber Configuration Mode Commands 
default  ▀   
Cisco ASR 5000 Series Command Line Interface Reference  ▄  
 
  OL-22948-01 
: configures the default multicast settings which is to discard PDUs 
: sets the quality of service setting to the system default. 
: Specifies the default IP source validation. Default is Enabled. 
 
: Disable copying of the IP TOS octet value to all tunnel encapsulation IP 
headers. 
Sets the tunnel load balancing algorithm to the system default. 
Sets the action that is taken when the long duration timer expires to the default: detection. 
: Disables the FA from accepting a home address assigned by an 
AAA server. 
:Sets home agent IP address to its default of 0.0.0.0. 
: Disables the FA validating the home address in the RRQ against the 
one assigned by AAA server. 
:Sets this parameter to its default of disabled. 
: Sets the encryption algorithm to the default of hmac-md5. 
:Sets this parameter to its default of enabled. 
:Sets this parameter to its default of none. 
: Disables the HA from sending the DNS address NVSE in the RRP. 
: Disables the FA from sending the terminal verification NVSE in the 
RRQ. 
Restores the subscriber‘s service usage defaults. 
Sets the point-to-point protocol option defaults. 
: Re-enables the PDSN to send special 3GPP2 VSE PPP packets to the Mobile 
Node with a max inactivity timer value for always on sessions. This configuration is applicable only for 
PDSNsessions. 
 { 
 | 
 }: restores the default value for either the data compression 
 or compression 
 as follows: 
 
mode stateless 
 
all protocols enabled 
: sets the IP header compressions negotiation to the system 
default: force. 
: sets the subscriber‘s PPP keep alive option to the system default: 30 seconds. 
: restores the PPP minimum packet size for compression: 128 octets. 
: sets the maximum message transfer unit packet size to the system default: 1500 octets.