Cisco Cisco Tunnel Terminating Gateway (TTG) トラブルシューティングガイド
Card Configuration Mode Commands
redundancy ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
redundancy
Configures the type of redundancy for a line card or SPIO.
Product
PDSN, FA, HA, GGSN, SSGN
Privilege
Security Administrator, Administrator
Syntax
Restores redundancy to
type redundancy.
Specifies no port redundancy is used. This is used mostly for legacy products.
Enables port redundancy on line cards or on SPIO cards.
This is the default setting used by the system.
This is the default setting used by the system.
Important:
Port-type redundancy does not affect line card failover/redundancy operations.
Important:
This feature is not yet fully supported.
With release 8.1 and higher, this keyword enables pseudo-APS type port redundancy on OLC2/CLC2 line
cards.
cards.
Instructs the system to execute the command without additional prompting for command confirmation.
Usage
Use this command to configure redundancy on a line card (LC) or a SPIO card. With
enabled,
if an external network device or cable failure occurs that causes a link down failure on the port, the redundant
port is used.
port is used.