Cisco Cisco Packet Data Gateway (PDG) トラブルシューティングガイド
APN Configuration Mode Commands
▀ default
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
mn-aaa-removal-indication : Disabled
required : Disabled
reverse-tunnel : Enabled
Restores the APN NPU QoS parameter to its default setting of Derive from packet DSCP.
Restores the APN pdp-type parameter to its default setting of ipv4.
Restores the APN ppp parameters to the following default settings:
data-compression mode: normal
data-compression protocols: stac, mppc, deflate
keepalive: 0
min-compression-size: 128
mtu: 1500
Restores the APN proxy-mip required parameter to its default setting of Disabled.
: Configures handling of RRQ to enable the acceptance without NAI extension in this APN.
Default: Disabled.
Configures handling of RRQ to enable the acceptance
without NAI extension in this APN. Default: Disabled.
This keyword is obsolete.
Restores the APN selection-mode parameter to its default setting of subscribed.
Configures payload compression by SGSN for this APN.
Restores the APN timeout parameters to the following default settings:
absolute : 0
idle : 0
load-balance : 0
qos-renegotiate : 180 - This keyword is obsolete.
This is the timeout value for the dampening timer during the dynamic QoS renegotiation.