Cisco Cisco Packet Data Interworking Function (PDIF) トラブルシューティングガイド
MME-HSS Service Configuration Mode Commands
▀ failure-handling
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22947-02
This keyword configures the MME-HSS service to handle the failures for various request message having
specific single or range of Diameter result code in request message.
specific single or range of Diameter result code in request message.
specifies the individual error code on Diameter protocol and must be an integer from
3000 through 5999. This will be the starting of code if a range of error codes is specified with optional
keyword
keyword
.
is used to specify a range of error codes to handle by this command.
specifies the end error code on Diameter protocol and must be an integer from 3000
through 5999.
This keyword configures the MME-HSS service to handle the failures for various request messages if
response to that message is not received before timeout duration exhausted.
response to that message is not received before timeout duration exhausted.
This keyword specifies the action to be taken on failure of any message as policy of failure handling.
continue: On receipt of any error, this action configuration will allow the MME-HSS service to
continue with the session procedure without any interruption.
retry-and-terminate: On receipt of any error, this action configuration will instruct the MME-HSS
service to retry with the procedure. Sustem will retry up to the configured number of attempts and
terminate the session/procedure if it received subsequent number of errors after retry attemps.
terminate the session/procedure if it received subsequent number of errors after retry attemps.
terminate: This action configuration will allow the MME-HSS service to terminate the session
procedure without any retry attemp on the event of any failure.
Usage
Use this command to configure the failure handling behavior in the event of a communication failure with the
MME-HSS service.
Following are the default action for Diameter result codes:
For all protocol error codes 3000 to 3999 the default action is terminate. For all transient error codes 4000,
4001, 4004 to 4180, and 4182 to 4999 the default action is continue.
For transient error codes 4002, 4003, and 4181 the default action is retry.
For error code 4001 the default action is terminate.
For permanent error codes 5000 to 5999 the default action is terminate
MME-HSS service.
Following are the default action for Diameter result codes:
For all protocol error codes 3000 to 3999 the default action is terminate. For all transient error codes 4000,
4001, 4004 to 4180, and 4182 to 4999 the default action is continue.
For transient error codes 4002, 4003, and 4181 the default action is retry.
For error code 4001 the default action is terminate.
For permanent error codes 5000 to 5999 the default action is terminate
Example
The following command will allow MME-HSS service to continue if any failure in Auth-Information-Request message
occurred with Diameter error code
The following command will allow MME-HSS service to continue if any failure in Auth-Information-Request message
occurred with Diameter error code
: