Cisco Cisco Packet Data Interworking Function (PDIF) トラブルシューティングガイド
SGTP Service Configuration Mode Commands
gtpc ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
This keyword is available in releases 8.1 and higher.
Default: disabled. To reset the default for this parameter, you must enter the following command:
Default: disabled. To reset the default for this parameter, you must enter the following command:
.
This keyword instructs the SGSN to ignore the response port validation.
For the SGSN to process incoming GTP responses to an incorrect port,
For the SGSN to process incoming GTP responses to an incorrect port,
this keyword must be entered, and
the same
must be configured for GTPC and GTPU in the SGTP service.
Default: 4
Configures the maximum number of retries for packets.
Configures the maximum number of retries for packets.
: Must be an integer from 0 to 15.
Default: 5
Configures the control packet retransmission timeout in GTP, in seconds.
Configures the control packet retransmission timeout in GTP, in seconds.
must be an integer value from 1 through 20.
: This option configures the SGTP service to include or exclude the common flags IE
during an Inter-SGSN RAU. When selected, the default is to send the common flags IE.
: This option configures the SGTP service to include/exclude the radio access bearer (RAB)
context IE in SGSN ‗context response‘ message during Inter-SGSN Routing Area Update procedure. Default
is to send the RAB context IE.
is to send the RAB context IE.
Usage
Use this command to configure GTP-C settings for the current SGTP service.
Example
Following command excludes the radio access bearer (RAB) context IE in the SGSN Context Response message during
the inter-SGSN RAU procedure:
Following command excludes the radio access bearer (RAB) context IE in the SGSN Context Response message during
the inter-SGSN RAU procedure: