Cisco Cisco Tunnel Terminating Gateway (TTG) トラブルシューティングガイド
NAT Configuration
Configuring NAT ▀
Cisco ASR 5000 Series Network Address Translation Administration Guide ▄
OL-22992-01
Configuring Access Ruledefs
To create and configure an access rule definition, use the following configuration:
Notes:
If the source IP address is not configured, then it is treated as any source IP.
If the destination IP address is not configured, then it is treated as any destination IP.
If the source port is not configured, then it is treated as any source port.
If the destination port is not configured, then it is treated as any destination port.
If no protocol is specified then it is treated as any protocol.
If both uplink and downlink fields are not configured, then the rule will be treated as either direction, i.e. packets
from any direction will match that rule.