Cisco Cisco Aironet 1310 Access Point Bridge インストールガイド
2
Read Me First
78-17100-02
Antenna Recommendations
Step 3
The access point/bridge default username and password and the enable password are all Cisco (case
sensitive).
sensitive).
Note
When your configuration changes are completed, you must remove the serial cable from the
console port.
console port.
You can use Cisco IOS commands to configure a static IP address on the BVI1 interface, which enables
you to browse or Telnet to the access point/bridge using Ethernet. For example:
you to browse or Telnet to the access point/bridge using Ethernet. For example:
ap#configure terminal
ap(config)#interface bvi1
ap(config-if)#ip address 10.0.0.1 255.255.255.0
ap(config-if)#exit
ap#write memory
Ethernet Port
When using a web browser (HTTP) or Telnet connection through the power injector’s Ethernet port,
follow these steps:
follow these steps:
Step 1
Connect the power injector's Ethernet port to a LAN containing a running DHCP server.
Step 2
Power up the access point/bridge unit.
Step 3
Check the DHCP server's lease table to find the IP address assigned to the access point/bridge’s client ID.
Step 4
Use the IP address to Telnet or browse to the access point/bridge. The default username and password
are both Cisco (case sensitive).
are both Cisco (case sensitive).
Antenna Recommendations
•
AIR-BR1310G-x-K9 has a single integrated antenna and is not configurable for antenna selection
(diversity/left/right). The x represents your regulatory region.
(diversity/left/right). The x represents your regulatory region.
•
AIR-BR1310G-x-K9-R does not ship with an antenna because many different external antennas can
be used with this product to cover various environments and applications. You must install one or
two external antennas. The x represents your regulatory region. For additional information on
antennas and accessories, refer to this URL:
be used with this product to cover various environments and applications. You must install one or
two external antennas. The x represents your regulatory region. For additional information on
antennas and accessories, refer to this URL:
–
If two diversity antennas are installed, Cisco recommends that you configure Diversity for the
antenna receive and antenna transmit settings.
antenna receive and antenna transmit settings.
–
If only one antenna is installed, Cisco recommends that you connect it to the right RP-TNC
antenna connector and that you configure Right (Primary) for the antenna receive and antenna
transmit settings.
antenna connector and that you configure Right (Primary) for the antenna receive and antenna
transmit settings.