Cisco Cisco Aironet 1310 Access Point Bridge

CSCee66841—When VLANs are enabled and WEP encryption is added to the infrastructure SSID, 
an access point in fallback repeater mode can now associate to a root access point and successfully 
pass traffic.

CSCee70832—When the primary ACS server fails, the access point now switches to the next ACS 
server in the access point’s server priority list.

CSCee17177—Memory allocation failures with multiple tracebacks observed

This caveat is not a defect and has been closed.

CSCee77277—Access points now correctly send these RADIUS accounting attributes: 
Acct-Input-Octets, Acct-Output-Octets, Acct-Input-Packets, and Acct-Output-Packets.

CSCee78082—Throughput is now the same for unicast and multicast packets sent by the access 
point.

CSCee78757—Non-Cisco client adapters now are able to associate to the 802.11g radio in an access 
point when OFDM data rates (6, 9, 12, 18, 24, 36, 48, and 54 Mbps) are enabled.

CSCee87254—You can now use the access point GUI to disable SSH.

CSCee90065—An access point with a default configuration no longer sends a DHCP request when 
you click the Network Interfaces: IP Address link on the access point GUI.

CSCef01790—When access point interfaces are configured to allow unicast-flooding and the 
configuration is saved, the unicast-flooding command is now applied after the unit reboots.

CSCef02795—Access point no longer allows simultaneous MAC-address authentication and 
WPA-PSK configurations.

CSCef06846—The access point no longer has a memory leak.

CSCef06976—Applying a service policy to input traffic on the access point radio interface to 
classify traffic now carries through to the 802.1d marking on the Ethernet trunk.

CSCef14899—The drop-down menu on online help pages now operates correctly.

CSCef23452—The access point data packet counter now increments correctly.

CSCef24269—The Time Server entry field now allows more than 15 characters on the Services: 
NTP page on the access point GUI.

CSCef41592—After booting from factory defaults, an access point now automatically sets its 
hostname to the name returned in the DNS PTR record corresponding to any of the access point’s 
IP addresses.

CSCef45558—BR1310 now loads default radio interface settings when configuring AP only mode.

CSCef46191—A specifically crafted TCP connection to a telnet or reverse telnet port of an access 
point running Cisco IOS software no longer blocks further telnet, reverse telnet, Remote Shell 
(RSH), Secure Shell (SSH), and HTTP access to the access point.

CSCef49603—The Cisco IOS Software Configuration Guide for Cisco Aironet Access Points now 
contains a description for the RADSRV-4-NAS_UNKNOWN error message.

CSCef53367—Access points no longer display runtime errors when you browse to the Express 
Setup page on the GUI.

CSCef53401—Client devices associated to an access point no longer fail to receive IP addresses 
from the DHCP server.

CSCef55725—Transmit power no longer drops on channel 14 on access points configured for use 
in Japan.