Cisco Cisco Aironet 350 Access Points

Enable accounting on the access point or bridge to send network accounting information about wireless 
client devices to a RADIUS server on your network. See the 

 of the Cisco Aironet Access Point Software Configuration Guide for instructions 

on enabling accounting.

Set up repeater access points and non-root bridges to authenticate to your network like other wireless 
client devices. After you provide a network username and password for the repeater or bridge, it 
authenticates to your network using LEAP, Cisco’s wireless authentication method, and receives and 
uses dynamic WEP keys. Click this link for instructions on setting up a repeater access point:

Click this link for instructions on setting up a non-root bridge:

You can find the latest release of access point and bridge firmware at the following URL:

Cisco Aironet 350 Series Bridges and metal-case access points are suitable for use in environmental air 
space in accordance with Section 300-22(c) of the National Electrical Code.

The Cisco Aironet power injector has a smaller operating temperature range (32 to 104

o

F; 0 to 40

o

C) 

than the 350 series bridge and metal-case access point. The power injector is not intended for use in 
extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.

For instructions on the proper installation and grounding of external antennas, refer to the National Fire 
Protection Association’s NFPA 70, National Electrical Code, Article 810, and the Canadian Standards 
Association’s Canadian Electrical Code, Section 54.