Cisco Cisco Identity Services Engine Software 技術マニュアル

Contributed by Vivek Santuka and Beau Wallace, Cisco TAC
Engineers.
Jan 15, 2013

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Background Information
 Configure
      Configuration Considerations for All Versions
      Configuration for ISE 1.1.1 and Later
 Related Information

This document describes how to configure guest accounts for any RADIUS−based authentication, as well as
portal−based authentication, on Cisco Identity Services Engine (ISE).

The procedures in this document require basic knowledge of Cisco Identity Services Engine (ISE) and IEEE
802.1x.

The information in this document is based on the Cisco Identity Services Engine (ISE).

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.

Refer to the Cisco Technical Tips Conventions for information on document conventions.

This feature described in this document works differently between ISE versions.

Before ISE 1.1.1: All guest accounts stay in an inactive state when they are created, and they are not
activated until the first log in through the guest portal. While in the inactive state, they cannot log in

•