Cisco Cisco AP541N Wireless Access Point メンテナンスマニュアル
Getting Started
Connecting the Access Point to a PC
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
5
1
Connecting the Access Point to the PC through a Network Connection
To connect the access point to an administration PC through the network:
STEP 1
Connect one end of an Ethernet straight-through or crossover cable to the network
port on the access point, as shown in
port on the access point, as shown in
Figure 2
.
STEP 2
Connect the other end to the same hub or switch where your PC is connected.
Figure 2 Connecting the Access Point Using a LAN Connection
The hub or switch you use must permit broadcast signals from the access point to
reach the other devices on the network.
reach the other devices on the network.
STEP 3
If you are not using PoE, connect the power adapter to the power port on the back
of the access point, then plug the other end of the power cord into a power outlet.
of the access point, then plug the other end of the power cord into a power outlet.