Cisco Cisco AMP Threat Grid 5004 Appliance インストールガイド
Cisco AMP Threat Grid Appliance Administrator's Guide
CONFIGURATION MANAGEMENT
CONFIGURATION MANAGEMENT
19
Using DHCP
Most Appliance users do not use a network configured with DHCP. However, if you are connected to a network
configured to use DHCP, then read this section.
configured to use DHCP, then read this section.
Note:
If the initial appliance network configuration used DHCP and you now need to switch to static IP
addresses, see Network Configuration and DHCP below.
TGSH Dialog displays the information you will need to in order to access and configure the OpAdmin Portal
interface.
interface.
The IP addresses for DHCP may not be displayed immediately after your Appliance boots. Please be patient!
Explicit DNS for DHCP
As of v1.3, systems using DHCP need to explicitly specify DNS. Previously, they did not. An upgrade of a system
without a DNS server explicitly specified to 1.3 will fail.
without a DNS server explicitly specified to 1.3 will fail.
Figure 9 - TGSH Dialog (Connected to a Network Configured to Use DHCP)
•
Admin URL: The Admin network. You will need this address in order to continue the remaining
configuration tasks with OpAdmin.
configuration tasks with OpAdmin.
•
Application URL: The Clean network.
Note:
This is the address to use after completing the configuration with OpAdmin, in order to access the
Threat Grid application.
•
The Dirty network is not shown.
•
Password is the initial administrator's password, which is randomly generated during the Appliance
installation. You will need to change this password later as the first step the OpAdmin configuration
process.
installation. You will need to change this password later as the first step the OpAdmin configuration
process.
If you plan on using DHCP on a permanent basis, then no additional network configuration is necessary, unless
you need to change the Admin IP address to static.
you need to change the Admin IP address to static.