Cisco Cisco Packet Data Gateway (PDG) 管理者ガイド
Getting Started
Using the CLI for Initial Configuration ▀
Cisco ASR 5000 System Administration Guide ▄
43
Step j
Configure the port speed, if needed, by entering the following command:
medium { auto | speed { 10 | 100 | 1000 | 10000 } duplex { full | half } }
Step k
Exit the Ethernet Interface Configuration mode by entering the command:
[local]host_name(config-port-slot#/port#)# exit
[local]host_name(config)#
[local]host_name(config)#
Important:
Refer below for instructions on configuring the SPIO management interface with a second
IP address.