Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security
2
Release Notes for WAP4410N Access Point Firmware Version 2.0.5.3
Release Notes
•
•
•
•
•
Changes Since WAP4410N Firmware Version 2.0.4.2
The firmware was updated and the following issues were fixed in firmware version
2.0.5.3.
2.0.5.3.
•
CSCtz79093—Wireless isolation functionality between (and within) SSIDs
is now fixed.
is now fixed.
•
CSCtz79020—Fixed inability to assign static IPv6 address using the web-
based configuration utility.
based configuration utility.
•
CSCtz79064—Added a separate IP-type setting option for IPv6 in the
web-based configuration utility.
web-based configuration utility.
•
CSCty33244—WPS can now be disabled using SSH.
•
CSCty33308—WPS is disabled by default. However, a factory reset must
be performed first — either press the Reset button for approximately 10
seconds, or use the web-based utility. Alternatively, you may choose to
disable WPS using SSH.
be performed first — either press the Reset button for approximately 10
seconds, or use the web-based utility. Alternatively, you may choose to
disable WPS using SSH.
Known Issues
These known issues were identified in firmware version 2.0.5.3.
•
CSCtz79103—When selecting a 128-bit WEP key and providing a
passphrase, one 128-bit key is generated. However, the default transmit
key radio buttons allow you to pick from keys 1 through 4. The radio buttons
for keys 2, 3, and 4 should be disabled.
passphrase, one 128-bit key is generated. However, the default transmit
key radio buttons allow you to pick from keys 1 through 4. The radio buttons
for keys 2, 3, and 4 should be disabled.
•
CSCtz05386—When enabling IPv6, the link local is not displayed on the
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.
status page. Workaround: SSH into the device and execute an ifconfig to
determine the link local.