Cisco Cisco Packet Data Gateway (PDG)
Interchassis Session Recovery
▀ Configuring Interchassis Session Recovery (ICSR)
▄ ASR 5500 System Administration Guide, StarOS Release 17
310
configure
context vpn_ctxt_name [-noconfirm]
interface srp_if_name
ip-address { ip_address | ip_address/mask }
exit
exit
port ethernet slot_num/port_num
description des_string
medium { auto | speed { 10 | 100 | 1000 } duplex { full | half } }
no shutdown
bind interface srp_if_name srp_ctxt_name
end
Verifying SRP Configuration
Step 1
Verify that your SRP contexts were created and configured properly by entering the show srp info command (Exec
Mode).
Mode).
Sample output for this command as shown. In this example, an SRP context called srp1 was configured with default
parameters.
parameters.
Service Redundancy Protocol:
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init
Peer Priority: 0
Peer Tiebreaker: 00-00-00-00-00-00
Peer Route-Modifier: 0
Last Hello Message received: -
Peer Configuration Validation: Initial
Last Peer Configuration Error: None
Last Peer Configuration Event: -
Connection State: None
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init
Peer Priority: 0
Peer Tiebreaker: 00-00-00-00-00-00
Peer Route-Modifier: 0
Last Hello Message received: -
Peer Configuration Validation: Initial
Last Peer Configuration Error: None
Last Peer Configuration Event: -
Connection State: None