Cisco Cisco Packet Data Gateway (PDG)
Specifies number of retransmission of keepalives to remote node without getting any response before the
remote node is marked as dead/down.
remote node is marked as dead/down.
retry must be an integer between 0 through 10.
Usage Guidelines
Use this command to configure the parameters for sending Keepalives to the remote end-point of GRE tunnel.
It also configures the interval at which GRE Keepalives are sent on the interface and number of retries without
getting a response from the remote end-point before the tunnel is shutdown. By default, Keepalives will not
be sent.
It also configures the interval at which GRE Keepalives are sent on the interface and number of retries without
getting a response from the remote end-point before the tunnel is shutdown. By default, Keepalives will not
be sent.
Examples
The following command enables the keepalive and sets the other parameters to defaults:
default keepalive
default keepalive
Command Line Interface Reference, Modes G - H, StarOS Release 19
1030
GRE Tunnel Interface Configuration Mode Commands
keepalive