Cisco Cisco Packet Data Interworking Function (PDIF)
Usage Guidelines
Use this command to associate a configured failure handling template with the DCCA service.
The failure handling template defines the action to be taken when the Diameter application encounters a failure
supposing a result-code failure, Tx-expiry or response-timeout. The application will take the action given by
the template. For more information on failure handling template configurations, refer to the Diameter Failure
Handling Template Configuration Mode Commands chapter.
supposing a result-code failure, Tx-expiry or response-timeout. The application will take the action given by
the template. For more information on failure handling template configurations, refer to the Diameter Failure
Handling Template Configuration Mode Commands chapter.
Only one failure handling template can be associated with the DCCA service. The failure handling template
should be configured prior to issuing this command.
should be configured prior to issuing this command.
Important
If the association is not made to the template then failure handling behavior configured in the application with
the failure-handling command will take its effect.
the failure-handling command will take its effect.
Examples
The following command associates a pre-configured failure handling template called fht1 to the DCCA service:
associate failure-handling-template fht1
associate failure-handling-template fht1
Command Line Interface Reference, Modes C - D, StarOS Release 19
993
Credit Control Configuration Mode Commands
associate