Cisco Cisco Packet Data Gateway (PDG)
threshold ha-service init-rrq-rcvd-rate
Sets an alarm or alert based on the average number of calls setup per second for an HA service.
Product
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
threshold ha-service init-rrq-rcvd-rate high_thresh [ clear low_thresh ]
no threshold ha-service init-rrq-rcvd-rate
no threshold ha-service init-rrq-rcvd-rate
no
Deletes the alert or alarm.
high_thresh
Sets the high threshold average number of calls setup per second that must be met or exceeded within the
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 1000000.
Default: 0
polling interval to generate an alert or alarm. It can be configured as an integer from 0 through 1000000.
Default: 0
clear low_thresh
Sets the low threshold average number of calls setup per second that must be met or exceeded within the
polling interval to clear an alert or alarm. It can be configured as an integer from 0 through 1000000. Default:
0
polling interval to clear an alert or alarm. It can be configured as an integer from 0 through 1000000. Default:
0
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Use this command to set an alert or an alarm when the average number of calls set upper second is equal to
or less than a specified number of calls per second.
or less than a specified number of calls per second.
Command Line Interface Reference, Modes C - D, StarOS Release 19
969
Context Configuration Mode Commands S-Z
threshold ha-service init-rrq-rcvd-rate