Cisco Cisco Packet Data Gateway (PDG)
location-service
Creates a location service configuration instance or configures an existing location service configuration and
enters the Location Service Configuration Mode. LoCation Services (LCS) are used to determine the geographic
location of a UE.
enters the Location Service Configuration Mode. LoCation Services (LCS) are used to determine the geographic
location of a UE.
Product
MME
SGSN
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
location-service service_name [ -noconfirm ]
no location-service service_name
no location-service service_name
no
Removes the specified location service configuration instance from the context.
service_name
Specifies the name of the location service configuration instance. If service_name does not refer to an existing
service, the new service is created if resources allow.
service, the new service is created if resources allow.
service_name is an alphanumeric string of 1 through 63 characters.
Service names must be unique across all contexts within a chassis.
Important
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage Guidelines
Enter the Location Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing Service Configuration instance.
command is also used to remove an existing Service Configuration instance.
Command Line Interface Reference, Modes C - D, StarOS Release 19
784
Context Configuration Mode Commands I-M
location-service