Cisco Cisco Packet Data Interworking Function (PDIF)
Use this command to configure the cause code returned to a UE when peer node resolution is not successful.
By default, the MME sends the UE the #9 - MS identity cannot be derived by the network cause code when
encountering this condition.
By default, the MME sends the UE the #9 - MS identity cannot be derived by the network cause code when
encountering this condition.
During processing of a TAU Request, the resolution of a peer MME that had allocated the temporary identity
that is signaled to the UE takes several steps in the MME. This resolution can be done based on DNS or based
on local configuration. This condition occurs when all mechanisms for peer node resolution are done with no
success.
that is signaled to the UE takes several steps in the MME. This resolution can be done based on DNS or based
on local configuration. This condition occurs when all mechanisms for peer node resolution are done with no
success.
If a cause code mapping is specified in both the call-control-profile associated with a call, and also the
mme-service, the cause configured for the call-control-profile will be signalled to the UE. See also the
local-cause-code-mapping command in the call-control-profile configuration mode. This command is
described in the Call Control Profile Configuration Mode Commands chapter.
mme-service, the cause configured for the call-control-profile will be signalled to the UE. See also the
local-cause-code-mapping command in the call-control-profile configuration mode. This command is
described in the Call Control Profile Configuration Mode Commands chapter.
Examples
The following command maps the "plmn-not-allowed" cause code to the peer node unknown condition:
local-cause-code-mapping peer-node-unknown emm-cause-code plmn-not-allowed
Command Line Interface Reference, Modes I - Q, StarOS Release 19
919
MME Service Configuration Mode Commands
local-cause-code-mapping peer-node-unknown