Cisco Cisco Packet Data Gateway (PDG)
default
Restores the default values.
no
This command deletes the Ethernet port from any group it might be in. If the port was the Master of a group,
the whole group would be deleted.
the whole group would be deleted.
Usage Guidelines
Configure from one to four ports on a QGLC (vertical aggregation) or the single port on XGLCs (horizontal
aggregation), or traffic ports on an MIO card to be in an aggregation group that links to an aggregation group
on a remote Ethernet switch. Very large files can be downloaded across all ports in a group, which makes for
a faster download when compared to serial downloads over a single link.
aggregation), or traffic ports on an MIO card to be in an aggregation group that links to an aggregation group
on a remote Ethernet switch. Very large files can be downloaded across all ports in a group, which makes for
a faster download when compared to serial downloads over a single link.
Related link-aggregation commands are described in the Card Configuration Mode Commands and Global
Configuration Mode Commands chapters of this guide. For additional information, also refer to the System
Administration Guide.
Configuration Mode Commands chapters of this guide. For additional information, also refer to the System
Administration Guide.
Examples
The following example configures the port to be part of Master Group 2:
link aggregation master group 2
link aggregation master group 2
Command Line Interface Reference, Modes E - F, StarOS Release 19
170
Ethernet Port Configuration Mode Commands
link-aggregation