Cisco Cisco ASR 5000
BFD Configuration Mode Commands
▀ bfd linkagg-peer
▄ Command Line Interface Reference, StarOS Release 18
1618
bfd linkagg-peer
Enables member-link based BFD and configures the BFD link aggregation (linkagg) session values. Member-link based
BFD detects individual link failures faster than LACP and reduces the overall session/traffic down period as a result of
single member link failure.
BFD detects individual link failures faster than LACP and reduces the overall session/traffic down period as a result of
single member link failure.
Product
ASR 5000, ASR 5500 all products
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > BFD Configuration
configure > context context_name > bfd-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-bfd)#
Syntax
bfd linkagg-peer linkagg_group_id local-endpt-addr local_endpt_ipaddress remote-endpt-
addr remote_endpt_ipaddress interval tx_interval min_rx rx_interval multiplier
multiplier_value [ slot slot_number ]
addr remote_endpt_ipaddress interval tx_interval min_rx rx_interval multiplier
multiplier_value [ slot slot_number ]
no bfd linkagg-peer linkagg_group_id [ slot slot_number ]
no
Disables this member-link BFD configuration.
linkagg_group_id
Specifies the LAG number as an integer from 1 through 255.
local-endpt-addr
local_endpt_ipaddress
Specifies the source address of the multihop BFD session in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal format.
hexadecimal format.
remote-endpt-addr
remote_endpt_ipaddress
Specifies the remote address of the Multihop BFD session in IPv4 dotted-decimal or IPPv6 colon-separated-
hexadecimal format.
hexadecimal format.
interval
tx_interval
Specifies the transmit interval of control packets in milliseconds as an integer from 50 through 10000.
min_rx
rx_interval
Specifies the minimum receive interval for control packets in milliseconds as an integer from 50 through
10000.
10000.