Cisco Cisco ASR 5000

ページ / 9109
ACS Host Pool Configuration Mode Commands   
▀  ip 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
612 
   
ip 
This command allows you to add/remove an individual or a range of host IPv4/IPv6 address(es) from the current host 
pool. 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > ACS Host Pool Configuration 
active-charging service service_name > host-pool host_pool_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs-host-pool)# 
Syntax
 
[ no ] ip { ipv4/ipv6_address ipv4/ipv6_address/maskbit | range start_ipv4/ipv6_address 
to end_ipv4/ipv6_address } 
no
 
If added previously, removes the specified IPv4/IPv6 address(es) from the current host pool. 
ipv4/ipv6_address
 
Specifies an IPv4/IPv6 address to add to the current host pool. 
ipv4/ipv6_address
 must be an IPv4/IPv6 address. 
ipv4/ipv6_address/maskbit
 
Specifies an IPv4/IPv6 address/mask bits combination to add to the current host pool. 
ipv4/ipv6_address
 must be an IPv4/IPv6 address. 
maskbit
 must be the number of bits in the subnet mask, and must be a numeric value. 
range start_ipv4/ipv6_address to 
 
end_ipv4/ipv6_address
 
Specifies a range of IPv4/IPv6 addresses to add to the current host pool. 
start_ipv4/ipv6_address
 specifies the starting IPv4/IPv6 address of the range, and must be less than 
end_ipv4/v6_address
end_ipv4/v6_address
 specifies the ending IPv4/IPv6 address of the range, and must be greater than 
start_ipv4/ipv6_address
Usage 
Use this command to add an individual or a range of IPv4/IPv6 addresses to a host pool. Up to 10 sets of 
IPv4/IPv6 addresses can be configured in each host pool. 
Example
 
The following command adds all IPv4 addresses from 
10.2.3.4
 through 
10.4.5.6
 to the current host pool: