Cisco Cisco Packet Data Gateway (PDG)
Crypto Template IKEv2-Dynamic Payload Configuration Mode Commands
▀ tsr
▄ Command Line Interface Reference, StarOS Release 18
3064
gateway will respond back with only one type depending upon the type of address received in the
Configuration Payload. For example,.if the gateway receives only INTERNAL_IP4_ADDRESS in
the Configuration Payload but both IPv4 and IPv6 addresses are in the TSrs, the GW will narrow
down only the IPv4 address, and ignore the IPv6 TSrs.
Configuration Payload. For example,.if the gateway receives only INTERNAL_IP4_ADDRESS in
the Configuration Payload but both IPv4 and IPv6 addresses are in the TSrs, the GW will narrow
down only the IPv4 address, and ignore the IPv6 TSrs.
IPv4 TSrs are not allowed inside IPv6 payloads.
IPv6 TSrs are not allowed inside IPv4 payloads.
Example
Use the following example to configure a TSr payload that specifies an IPv4 address range for the payload:
tsr start-address 10.2.3.4 end-address 10.2.3.155