Cisco Cisco Packet Data Gateway (PDG)
PDSN Service Configuration Mode Commands
▀ qos-profile-id-mapping
▄ Command Line Interface Reference, StarOS Release 18
7990
Specifies the permitted packet drop rate in percentage for traffic flow to this QoS profile.
drop_percentage
must be an integer value between 0 and 1000.
latency
latency_duration
Default: 1000
Specifies the permitted latency duration in milli-seconds for this QoS profile.
Specifies the permitted latency duration in milli-seconds for this QoS profile.
latency_duration
must be an integer value between 0 and 1000.
qos-class
{
class-A
|
class-B
|
class-C
|
class-D
|
class-E
|
class-F
}
Default: Class-C
Specifies the type of QoS class associated with this QoS profile
class-A: Specifies the A type of QoS class.
class-B: Specifies the B type of QoS class.
class-C: Specifies the C type of QoS class.
class-D: Specifies the D type of QoS class.
class-E: Specifies the E type of QoS class.
class-F: Specifies the F type of QoS class.
Specifies the type of QoS class associated with this QoS profile
class-A: Specifies the A type of QoS class.
class-B: Specifies the B type of QoS class.
class-C: Specifies the C type of QoS class.
class-D: Specifies the D type of QoS class.
class-E: Specifies the E type of QoS class.
class-F: Specifies the F type of QoS class.
uplink-bw
ul_bw
Default: 32
Specifies the uplink (from the MN) data traffic bandwidth in kilo-bits per second for this QoS profile.
Specifies the uplink (from the MN) data traffic bandwidth in kilo-bits per second for this QoS profile.
ul_bw
must be an integer value between 0 and 100000.
+
More than one of the above keywords can be entered within a single command.
Usage
Use this command to define the values associated with the profile ID on the PDSN. This profile ID is used
during the mapping to and from the authorized QoS to the QoS parameters for the A10 link. This mapping is
required because the PDSN only knows the profile IDs and not the actual configured values for the profile ID
in the RAN. Also this configuration allows the use of custom profile IDs for the subscribers.
If no values are defined with a QoS profile ID, the values from matching QoS profile ID from RAN will be
applicable to the subscriber traffic.
during the mapping to and from the authorized QoS to the QoS parameters for the A10 link. This mapping is
required because the PDSN only knows the profile IDs and not the actual configured values for the profile ID
in the RAN. Also this configuration allows the use of custom profile IDs for the subscribers.
If no values are defined with a QoS profile ID, the values from matching QoS profile ID from RAN will be
applicable to the subscriber traffic.
Example
The following command sets the downlink bandwidth to
32
kbps, latency duration as
1000
ms, uplink
bandwidth to
32
kbps, and QoS class to Class-C for the QoS profile ID
11
in a PDSN service:
default qos-profile-id-mapping profile-id 11