Cisco Cisco ASR 5700
BGP Configuration Mode Commands
neighbor ▀
Command Line Interface Reference, StarOS Release 17 ▄
1657
next-hop-self
Disables the next hop calculation for this neighbor.
password password
Specifies a password that is only used inside configuration files. This should be an alphanumeric string of 1
through 24 characters.
through 24 characters.
remote-as
AS_num
Specify the AS number of the BGP neighbor.
AS_num
: Specifies the neighbor’s AS number as an integer from 1 through 65535.
remove-private-AS
Removes the private AS number from outbound updates. Default: Do not remove the private AS number.
restart-time rest_time
Specifies the maximum time (in seconds) required for a neighbor to restart.
rest_time
must be an integer
between 1 and 3600.
route-map
map_name
{ in | out }
Applies a route map to the neighbor.
map_name
i s the name of an existing route-map in the current context.
in
: Indicates that the route map applies to incoming advertisements.
out
: Indicates that the route map applies to outgoing advertisements.
send-community { both | extended | standard }
Sends the community attributes to a peer router (neighbor).
both
: Sends extended and standard community attributes.
extended
: Sends extended community attributes.
standard
: Sends standard community attributes.
shutdown
Administratively shuts down this neighbor. This disables exchanging routes or configuring parameters for
this neighbor.
this neighbor.
srp-activated-soft-clear
Enables BGP updates when Service Redundancy Protocol SRP-enabled resources are modified.
timers {[ connect-interval
conn_time ] | [ keepalive-interval
keep_time
holdtime-
interval
hold_time ]}
Specifies BGP timers for this neighbor.
connect-interval
conn_time
: Specifies the connect timer in seconds.
conn_time
must be an integer
from 0 through 65535. The default is 60 seconds.
keepalive-interval
keep_time
: The frequency (in seconds) at which the current BGP router sends
keepalive messages to its neighbor.
keep_time
must be an integer from 0 through 65535. The default is 30
seconds.
Holdtime-interval
hold_time
: The interval (in seconds) the router waits for a keepalive message before
declaring a neighbor dead.
hold_time
must be an integer from 0 through 65535. The default is 90 seconds.