Cisco Cisco ASR 5700
ACS Bandwidth Policy Configuration Mode Commands
▀ group-id
▄ Command Line Interface Reference, StarOS Release 17
384
violate-action { discard | lower-ip-precedence }
Specifies the action to be taken if Peak Data Rate is surpassed.
discard
: Specifies to discard the packet
lower-ip-precedence
: Specifies to lower IP precedence of the packet
committed-data-rate committed_data_rate
Specifies the committed Data Rate, in bits per second. This can also be used to specify the Guaranteed Bit
Rate (GBR) for Network Controlled QoS (NCQoS) without exceed-action.
Rate (GBR) for Network Controlled QoS (NCQoS) without exceed-action.
committed_data_rate
must be an integer from 1 through 4294967295.
Default: 0
committed-burst-size committed_burst_size
Specifies the committed burst size, in bytes.
committed_burst_size
must be an integer from 1 through 4294967295.
Default: 0
exceed-action { discard | lower-ip-precedence }
Specifies the action to be taken if Committed Data Rate is surpassed.
discard
: Specifies to discard the packet.
lower-ip-precedence
: Specifies to lower IP precedence of the packet.
Usage
Use this command to configure the Group ID for an bandwidth policy.
Example
The following command configures the group ID
111
to control bandwidth in the downlink direction
specifying peak data rate of
10000
bits per second and peak burst size of
10000
bytes while specifying the
action to be taken on violation as discard:
group-id 111 direction downlink peak-data-rate 10000 peak-burst-size
10000 violate-action discard
10000 violate-action discard