Cisco Cisco ASR 5700
Exec Mode Commands (T-Z)
traceroute6 ▀
Command Line Interface Reference, StarOS Release 17 ▄
4219
src_host_name
: specifies the remote node using its logical host name which must be resolved via a DNS
lookup.
src_host_ipv6_address
: specifies the remote node using its assigned IP address specified entered using
IIPv6 colon-separated-hexadecimal notation.
timeout
seconds
Specifies the maximum time (in seconds) to wait for a response from each route tracing packet as an integer
from 2 through 100. Default: 5
from 2 through 100. Default: 5
vrf
vrf_name
Specifies the name of an existing virtual routing and forwarding (VRF) context associated with this route as
an alphanumeric string of 1 through 63 characters.
an alphanumeric string of 1 through 63 characters.
grep
grep_options
|
more
Pipes (sends) the output of this command to the specified command. You must specify a command to which
the output of this command will be sent.
For details on the usage of
the output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter in this guide.
Usage
Trace an IPv6 route when troubleshooting network problems where certain nodes are having significant
packet delays or packet loss. This can also be used to identify bottlenecks in the routing of data within the
network.
packet delays or packet loss. This can also be used to identify bottlenecks in the routing of data within the
network.
Example
The following command traces the route to remote host
remoteABC
and sends the output to the more
command.
traceroute6 remoteABC | more
The following command traces the route to remote host
2000:4A2B::1f3F
’s port
2047
waiting a maximum
of
2
seconds for responses.
traceroute6 2000:4A2B::1f3F port 2047 timeout 2