Cisco Cisco ASR 5700
IuPS Service Configuration Mode Commands
▀ relocation-complete-timeout
▄ Command Line Interface Reference, StarOS Release 17
6772
relocation-complete-timeout
This command specifies the maximum time for the SGSN to wait for a Relocation Completion from the core network.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > IuPS Service Configuration
configure > context context_name > iups-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx-iups-service)#
Syntax
relocation-complete-timeout timeout_value
default relocation-complete-timeout
default
Resets the configuration to a 5 second wait time.
timeout_value
Time in seconds that the SGSN waits for relocation to be completed.
timeout_value
: Must be an integer from 1 to 60.
Default : 5 seconds.
Usage
Use this command to configure the number of seconds the SGSN will wait for a relocation to be completed.
This timeout needs to be set with sufficient time so that SRNS procedure aborts can be avoided if the peer
fails to respond in a timely fashion in the case of a hard handoff.
This timeout needs to be set with sufficient time so that SRNS procedure aborts can be avoided if the peer
fails to respond in a timely fashion in the case of a hard handoff.
Example
The following command sets the wait time for
10
seconds.
relocation-complete-timeout 10