Cisco Cisco ASR 5700
ACS Configuration Mode Commands
▀ charging-action
▄ Command Line Interface Reference, StarOS Release 17
450
charging-action
This command allows you to create/configure/delete ACS charging actions.
Important:
A maximum of 2048 charging actions can be configured in the active charging service.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
[ no ] charging-action charging_action_name [ -noconfirm ]
no
If previously configured, deletes the specified charging action from the active charging service.
charging_action_name
Specifies the charging action to add/configure/delete.
charging_action_name
must be the name of a charging action, and must be an alphanumeric string of 1
through 63 characters and can contain punctuation characters. Each charging action must have a unique
name.
If the named charging action does not exist, it is created, and the CLI mode changes to the ACS Charging
Action Configuration Mode wherein the charging action can be configured.
If the named charging action already exists, the CLI mode changes to the ACS Charging Action
Configuration Mode for that charging action.
name.
If the named charging action does not exist, it is created, and the CLI mode changes to the ACS Charging
Action Configuration Mode wherein the charging action can be configured.
If the named charging action already exists, the CLI mode changes to the ACS Charging Action
Configuration Mode for that charging action.
-noconfirm
Specifies that the command must execute without prompting for confirmation.
Usage
Use this command to create/configure/delete an ACS charging action.
A charging action represents actions to be taken when a configured rule is matched. Actions could range from
generating an accounting record (for example, an EDR) to dropping the IP packet, etc. The charging action
will also determine the metering principle—whether to count retransmitted packets and which protocol field
to use for billing (L3/L4/L7 etc).
On entering this command, the CLI prompt changes to:
A charging action represents actions to be taken when a configured rule is matched. Actions could range from
generating an accounting record (for example, an EDR) to dropping the IP packet, etc. The charging action
will also determine the metering principle—whether to count retransmitted packets and which protocol field
to use for billing (L3/L4/L7 etc).
On entering this command, the CLI prompt changes to:
[context_name]hostname(config-charging-action)#