Cisco Cisco Packet Data Gateway (PDG)
MME SGs Service Configuration Mode Commands
▀ non-pool-area
▄ Command Line Interface Reference, StarOS Release 16
7188
non-pool-area
Configures a non-pool area where a group of Location Area Code (LAC) values use a specific visitor Location Register
(VLR).
(VLR).
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME SGs Service Configuration
configure > context context_name > sgs-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgs-service)#
Syntax
non-pool-area name use-vlr vlr_name [ lac value(s) ] [ plmnid { any | mcc mcc_value mnc
mnc_value } ]
mnc_value } ]
no non-pool-area name [ lac value(s) ]
no non-pool-area name [ lac value(s) ]
Removes the configured non-pool-area from this service. Optionally, removes a specific LAC or LACs from
this non-pool area.
this non-pool area.
name
is the name of an existing non-pool-area expressed as an alphanumeric string of 1
through 63 characters.
value(s)
is an existing LAC integer value from 1 through 65535.
name
Specifies the name of the non-pool area as an alphanumeric string of 1 through 63 characters.
use-vlr vlr_name
Specifies the VLR to be used in this non-pool area configuration as an alphanumeric string of 1 through 63
characters.
characters.
lac value(s)
Specifies the location area code or codes to be used with the configured VLR in this non-pool area
configuration.
configuration.
value(s)
is an integer(s) from 1 through 65535.
In Release 12.2 and later, a maximum of 96 areas can be added per non pool area (in a single line, or
separately). In older releases, a total of 16 area codes can be added (in a single line, or separately).
separately). In older releases, a total of 16 area codes can be added (in a single line, or separately).
plmnid { any | mcc mcc_value mnc mnc_value }
Specifies the Public Land Mobile Network (PLMN) identifier to be used with the VLR in this non-pool area
configuration.
configuration.
any
: Specifies that any PLMN ID can be used with the VLR in this configuration.