Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
asn-policy ▀
Command Line Interface Reference, StarOS Release 16 ▄
8487
allow
Default: enabled
Enables the policy for this subscriber to allow idle mode operation in an ASN-GW service.
Enables the policy for this subscriber to allow idle mode operation in an ASN-GW service.
disallow
Default: disabled
Enable the policy for this subscriber to disallow idle mode operation in an ASN-GW service.
Enable the policy for this subscriber to disallow idle mode operation in an ASN-GW service.
classifiers downlink
Sets the classifier policy for all service flows coming from HA to FA for this subscriber’s matching classifier.
strict
Default: disabled
This option discards all the service flows coming from HA to FA and any other packets not matching to any
of the classifiers set for this subscriber.
This option discards all the service flows coming from HA to FA and any other packets not matching to any
of the classifiers set for this subscriber.
loose
Default: enabled
This option allows all the service flows coming from HA to FA and any other packet does not matching to
any of the classifiers set for this subscriber and sent to the BS/MS over downlink flow
This option allows all the service flows coming from HA to FA and any other packet does not matching to
any of the classifiers set for this subscriber and sent to the BS/MS over downlink flow
auth-only
Specifies whether the call is Auth only or not.
allow
Enables the policy for this subscriber to allow auth-only in an ASN-GW service.
disallow
Default
Disables the policy for this subscriber to allow auth-only in an ASN-GW service.
Disables the policy for this subscriber to allow auth-only in an ASN-GW service.
ms-requested classifiers
Default: allow
By default ASNGW allows dynamic addition of classifiers by the MS during MS-initiated service flow
creation or modification.
By default ASNGW allows dynamic addition of classifiers by the MS during MS-initiated service flow
creation or modification.
Usage
Use this command to configure subscriber policy to allow/disallow the idle mode operation or the downlink
traffic flow for a subscriber in an ASN-GW service.
For authentication configuration, the ASN-GW supports the Initial Network Entry (INE) for Ethernet CS
calls. The base station supports Ethernet CS traffic to the network. The INE procedure includes the
Authentication of the service flows and IP-Address allocation through DHCP. Authentication is based on the
Extensible Authentication Protocol (EAP).
This command allows MS to transition to idle mode with an ASN-GW.
traffic flow for a subscriber in an ASN-GW service.
For authentication configuration, the ASN-GW supports the Initial Network Entry (INE) for Ethernet CS
calls. The base station supports Ethernet CS traffic to the network. The INE procedure includes the
Authentication of the service flows and IP-Address allocation through DHCP. Authentication is based on the
Extensible Authentication Protocol (EAP).
This command allows MS to transition to idle mode with an ASN-GW.
Example
The following command configures the policy to allow the idle mode for an MS with an ASN-GW: