Cisco Cisco Packet Data Gateway (PDG)

ページ / 134
ePDG Support
Error Code
Value
The ePDG sends this code when the CP
payload (CFG_REQUEST) was expected
but not received.
FAILED_CP_REQUIRED
37
The ePDG sends this code when the TSi
and/or TSr parameters contain IP protocol
values other than 0.
TS_UNACCEPTABLE
38
The ePDG does not send this code because
the selector range is not checked and ingress
filtering is applied instead.
INVALID_SELECTORS
39
when it is under collision scenarios as
specified in RFC 5996.
TEMPORARY_FAILURE
40
when it is under collision scenarios as
specified in RFC 5996.
CHILD_SA_NOT_FOUND
41
The following tale lists the IKEv2 error codes expected by the ePDG from the WLAN UEs.
Table 26: IKEv2 Error Codes Expected by the ePDG
ePDG Behavior Upon Receipt
Error Code
Value
The ePDG sends an INFORMATIONAL
(Delete) message and deletes the session
information.
UNSUPPORTED_CRITICAL_PAYLOAD
1
The ePDG ignores the error message and
maintain the state of existing SAs.
INVALID_IKE_SPI
4
The ePDG sends an INFORMATIONAL
(Delete) message and deletes the session
information.
INVALID_SYNTAX
7
The ePDG deletes the session information
without sending an INFORMATIONAL
(Delete) message.
INVALID_MESSAGE_ID
9
When notified in an IKE_SA message, the
ePDG sends an INFORMATIONAL (Delete)
message and deletes the session information.
When notified outside an IKE_SA message,
the ePDG ignores the error message and
maintain the state for any existing SAs.
INVALID_SPI
11
ePDG Administration Guide, StarOS Release 19    
121
IKEv2 Error Codes and Notifications