Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch メンテナンスマニュアル
Single Point Setup
Access Points
Cisco WAP131 and WAP351 Administration Guide
177
11
Adding a WAP Device to a Single Point Setup
To add a new WAP device that is currently in standalone mode into a Single Point
Setup cluster:
Setup cluster:
STEP 1
Go to the configuration utility of the standalone WAP device.
STEP 2
Select Single Point Setup > Access Points.
STEP 3
Set the Cluster name to the same name that is configured for the cluster
members.
members.
STEP 4
(Optional) In the Location field, enter a description of where the WAP device is
physically located.
physically located.
STEP 5
Click Enable Single Point Setup.
The WAP device automatically joins the Single Point Setup.
Removing a WAP Device from a Single Point Setup
To remove a WAP device from the Single Point Setup cluster:
STEP 1
In the table showing the detected devices, click the IP address for the clustered
WAP device that you want to remove.
WAP device that you want to remove.
The configuration utility for that WAP device appears.
STEP 2
Select Single Point Setup > Access Points.
STEP 3
Click Disable Single Point Setup.
The Single Point Setup status field for that WAP device will now show Disabled.
Navigating to Configuration Information for a Specific Device
All WAP devices in a Single Point Setup cluster reflect the same configuration (if
the configurable items can be propagated). It does not matter which WAP device
you connect to for administration—configuration changes on any WAP device in
the cluster are propagated to the other members.
the configurable items can be propagated). It does not matter which WAP device
you connect to for administration—configuration changes on any WAP device in
the cluster are propagated to the other members.