Cisco Cisco Prime Network Registrar 8.0 トラブルシューティングガイド

 

 

As indicated previously, you must keep current copies 
of the default.incontrol and incstatus files from the 

Production Executive on the DR Executive.  Both files 
are located in $INCHOME/etc.  When copied to the 

DR Executive, they must be named 
default.incontrol.primary and incstatus.primary, 

respectively. 

 

This section describes the procedure necessary to initiate a DR 

event or exercise under this scenario. 

Change the IP address and associated parameters, including 

netmask and gateway, for the network interface using the 
accepted method of defining IP addressing information on that 

platform.  For example, on Red Hat this can be done using 
system-config-network

.  The IP address must be set 

to the IP address of the failed Production Executive, which 

must be offline. 

 

In order to “promote” the DR Executive so that it may 

become the Production Cisco Prime Network Registrar IPAM 
Executive, you must run the PromoteExec.sh script provided 

in the $INCHOME/etc/support directory of the Cisco Prime 
Network Registrar IPAM installation: 
> $INCHOME/etc/support/PromoteExec.sh