Cisco Cisco ONS 15454 M2 Multiservice Transport Platform (MSTP)
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Retrieve or higher
Security Level
Procedure
Step 1
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the DWDM, TXP, or MXP card where
you want to view near end PM counts. The card view appears.
you want to view near end PM counts. The card view appears.
Step 2
Click the Performance tab.
Step 3
If you want to view the near-end PM counts for a subtab, click the relevant subtab(s), located on the left side of the
Performance tab.
Performance tab.
Performance subtabs vary depending on the
card.
card.
Note
Step 4
If you want to view near-end PM counts for a specific port, select the port from the Ports drop-down list (where available).
Step 5
Click the Near End radio button, where available. (Viewing near-end PM counts is not available on some tabs.)
Step 6
Click Refresh. All current PM parameters for the selected card on the incoming signal appear.
Step 7
View the Curr column to find PM counts for the current time interval.
Step 8
View the Prev-n columns to find PM counts for the previous time intervals.
Step 9
Return to your originating procedure (NTP).
DLP-G134 View Far-End PM Counts
This task enables you to view far-end PM parameters for the
selected card and port.
selected card and port.
Purpose
None
Tools/Equipment
"DLP-G46 Log into CTC" task at
document.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Retrieve or higher
Security Level
55