Cisco Cisco Broadband Access Center for Cable 2.7
Introduction
4
Release Notes for Broadband Access Center for Cable 2.7
78-15814-03
System Requirements
You must have the Solaris 8 or 9 operating system, and Cisco Network Registrar
installed on your system to successfully use the BACC software.
installed on your system to successfully use the BACC software.
Note
The minimum Network Registrar version required to install BACC 2.7 is Network
Registrar 5.5 although the recommended version is 6.1.2.3.
Registrar 5.5 although the recommended version is 6.1.2.3.
Hardware Considerations
The minimum hardware requirements needed to support a lab and a fully deployed
network are completely described in the Cisco Broadband Access Center for
Cable Installation Guide.
network are completely described in the Cisco Broadband Access Center for
Cable Installation Guide.
Note
Processing capacity, disk storage, and memory requirements depend on the size
of the network deployment and the amount of log information needed.
of the network deployment and the amount of log information needed.
Device Provisioning Engine 590
All installation and connection issues are discussed in the Cisco Content Engine
500 Series Hardware Installation Guide that accompanies this product.
500 Series Hardware Installation Guide that accompanies this product.
Device Provisioning Engine 2115
All installation and connection issues are discussed in the Installation and Setup
Guide for the Cisco 1102 VLAN Policy Server. You should refer to that guide to
identify various ports and connectors, and to install the device.
Guide for the Cisco 1102 VLAN Policy Server. You should refer to that guide to
identify various ports and connectors, and to install the device.