Cisco Cisco Prime Optical 9.6 テクニカルリファレンス

If you want to create a new topology or add a new ML card to an existing RPR topology, you must 
first download a new barebone file to the ML card, thereby reinitializing the card.

You can download a barebone file to multiple ML cards. For details, see the section “Initializing 
ML-Series Cards” in Chapter 7, “Provisioning Services and Connections” in the 

.

Do not remove any of the information from the barebone file provided by Prime Optical. You can 
customize the username and password, but do not remove them; the username cannot be blank. Do not 
add the enable password password command, because Prime Optical cannot interactively enable a 
password.

Reset the ML-series card after loading the barebone file and wait for 5 minutes before provisioning 
topologies and services. The login and password are reported in the Control Panel window. You can 
create other profiles on ML-series cards by using the IOS Users table (available under Administration > 
CTC-Based NEs > IOS Users Table).

After entering command-line interface (CLI) commands through the Telnet session, Prime Optical issues 
a write or copy run start command to write the Cisco IOS configuration file to the Timing, 
Communications and Control (TCC) flash. When the Cisco IOS configuration file is written to the TCC 
flash (by Prime Optical or by another user), Prime Optical is notified. To verify that Prime Optical has 
been notified, enter the write command after any CLI change.

Prime Optical provides a GUI wizard to facilitate provisioning of L2 topologies and related L1 circuits. 
See the section “Provisioning Data Services” in Chapter 7, “Provisioning Services and Connections” in 
the 

. Create an RPR or point-to-point topology involving some of 

the ML-series cards in the network. Based on the L2 topology circuit type and size that you specify, 
Prime Optical creates related L1 circuits and installs a base card configuration on each ML-series card 
in the RPR ring.

The Create Layer 2 Service wizard guides you through the VLAN creation. There is no CLI to create a 
circuit VLAN. An RPR supports from 1 to 4095 VLANs, and these VLANs are enabled at all times. All 
that is required is to configure the endpoint to connect a ring VLAN to a port VLAN that is either an 
Ethernet port or a port channel. Only ML devices are supported on an RPR.

Point-to-point topologies are supported for ML-ML, ML-G1000, ML-OC, and ML-CE cards. 
Point-to-point topology creation is similar to RPR creation in that based on the L2 topology circuit type 
and size that you specify, Prime Optical creates related L1 circuits and installs a base card configuration 
on each ML-series card in the point-to-point topology.

To remove NEs from an L2 topology, mark the NEs Out of Service, and wait an appropriate amount of 
time for the L2 topology and corresponding links to be automatically deleted. Once automatic deletion 
is confirmed, delete the NEs.