Cisco Cisco Prime Network 3.10 インストールガイド

After entering the information at the prompts, a connection is made to the gateway to retrieve SSH keys. If the SSH keys are 
not retrieved automatically within 60 seconds, the following message is displayed: “Connection to gateway-IP-address failed. 
60 seconds timeout exceeded.” To resolve this issue, verify that the unit can reach port 6081 on the gateway and then run 
network-conf again.

If more than one IP address is defined on the unit server, Prime Network automatically chooses the IP address of the 
network interface card (NIC) that acts as a default route to the gateway. If required, you can use the choose_nic.pl tool 
to change the NIC.

Click Next. The system configuration might take some time. The Pre-installation summary appears. 

Click Install to start the Unit installation.

When the installation is complete, click Finish.

A prompt appears to start the unit. Click Yes to start the unit or No to start later. 

When the unit is installed, the new unit is displayed in the Prime Network Administration navigation tree and content area. It 
is automatically registered in the registry and a transport uplink between the unit and the gateway is created. The gateway starts 
the unit automatically, if the unit is reachable. 

The unit is displayed as Down at first but the status changes to Up after a few minutes. 

Remote procedure call (RPC) services (such as Prime Network SSH and Local Management over HTTP must be enabled 
in the gateway so that the gateway and the unit can communicate.

Right-click on the unit and select Properties to view memory allocation information for the unit, and other unit properties.

Prime Network Application 
Admin Password

The password for the Prime Network 
administrator.

Select the unit’s work mode 

Select Active Unit or Standby Unit as required.

Unit Unique Name

Name of the unit.

Units’s Protection Group

Enter the protection group for the unit.

Prime Network Main Schema 
Database IP address accessible 
from Prime Network Unit 

IP address of the Prime Network main schema 
database.

This is required in case of incase of 
incompatible Gateway/Database 
interface types.

Prime Network EP Schema 
Database IP address accessible 
from Prime Network Unit

IP address of the Prime Network EP schema 
database.