Cisco Cisco Prime Central 1.5.2 インストールガイド

Integrating Cisco Prime Access Registrar (CPAR) with Prime Central

Procedure

Step 1

From the Fault Source Management portlet, click Add to add the Fault Source details.
The Add New Fault Source dialog box appears.

Step 2

Enter the Fault Source Type from the drop-down as CAR and specify the Fault Source details in the appropriate fields.

Step 3

Click OK.
For more Information about how to add a Fault Source and the field descriptions, refer to the section Adding a Fault
Source in the

After the CPAR Fault Source is added, CPAR is registered with Prime Central as a domain manager instance.

Note

Configuring Prime Central as Trap Listener in CPAR to Receive Traps

Procedure

Step 1

Step 2

Go to CPAR installation directory and change it to /ucd-snmp/share/snmp directory.

Step 3

Add the following command to snmpd.conf file.
trap2sink <<ip-addr-FM-Server>> public <FM-port>

The Prime Central Fault Management SNMP port is 1162.

Note

Step 4

To reflect the changes, enter the following command for restarting the CPAR server:
cd <CPAR installation directory>/bin

./arserver restart

Step 5

Check if the following options, in the path /radius/advanced/snmp (in aregcmd prompt), are enabled:
enabled = true

masteragent = true

Step 6

If the above options are not enabled, perform the following steps to enable these options:

a) Go to <CPAR-Installation directory>/bin.
b) Enter the following commands:

./aregcmd

cd /radius/advanced/snmp

set enabled true

set masteragent true

save

reload