Cisco Cisco 1 GHz GainStar Node インストールガイド
2-26
Installation and Configuration
4035009 Rev B
Closing the Mini Node Housing
To Close the Mini Node Housing
Complete the following steps to close the Mini Node housing.
1
Make sure that the housing gaskets are clean and in the correct position. Wipe
off any excess dirt and debris.
off any excess dirt and debris.
2
Close the housing.
3
Lightly secure the six ½-inch closure bolts with a hex driver or ratchet.
4
Using a torque wrench, tighten the six closure bolts to 2.8 Nm.
Important: Tighten the closure bolts in the correct sequence as specified in
Torquing Sequence (on page 2-2).
Important: Tighten the closure bolts in the correct sequence as specified in
Torquing Sequence (on page 2-2).
5
Using the same pattern, tighten the housing closure bolts from 6.8 Nm to 9.0
Nm.
Nm.
Torquing Sequence
The following diagram shows the proper torquing sequence for the housing closure
bolts.
bolts.