Cisco PowerKEY CableCARD Module インストールガイド
Installing the PCG Bootup Files
78-4017672-01 Rev E
17
Installing the PCG Bootup Files
The PCG Boot CD contains files that will enable the PCG device to boot. Complete
the following steps to install the PCG Boot Software.
1 At the pcg login: prompt, enter the root user name and press Enter
2 At the Password: prompt, enter the root password and press Enter
the following steps to install the PCG Boot Software.
1 At the pcg login: prompt, enter the root user name and press Enter
2 At the Password: prompt, enter the root password and press Enter
Note: The well-known password is not included in this document. If you require
assistance contact Cisco Services.
assistance contact Cisco Services.
3 Press the CD eject button to open the drive. Place the PCG Bootup Installation
CD into the drive tray and close the tray.
4 Follow these instructions to install the PCG Boot application:
a Type mkdir /media/cdrom and then press Enter.
b Type mount /dev/cdrom /media/cdrom and then press Enter.
c Type cd /media/cdrom and then press Enter.
d Type ./autoinstall and then press Enter.
b Type mount /dev/cdrom /media/cdrom and then press Enter.
c Type cd /media/cdrom and then press Enter.
d Type ./autoinstall and then press Enter.
Important: The PCG will display diagnostic information and will list the
MAC addresses of the two Ethernet interfaces. You must write these two
values in a safe place. They will be needed for PCG configuration.
MAC addresses of the two Ethernet interfaces. You must write these two
values in a safe place. They will be needed for PCG configuration.
e Affix a label on the front of the PCG chassis with the MAC address returned
for the DNCS/ISDS-facing network interface.
Note: It is important to label the PCG with the ISDS-facing network interface
MAC address to expedite the PCG replacement process in the event of an
active PCG failure.
MAC address to expedite the PCG replacement process in the event of an
active PCG failure.
f Type cd / and then press Enter.
g Type eject cdrom and then press Enter.
g Type eject cdrom and then press Enter.
5 Did the PCG display diagnostic information and list the MAC addresses of the
two Ethernet interfaces, indicating that the installation was successful?
If yes, continue with the Installing the PCG Application Software (on page
18) section.
18) section.
If no, contact Cisco Services.