Cisco Cisco D9804 Multiple Transport Receiver インストールガイド
Configuring the Setup Information
78-4042990-01 Rev B
111
Setting up the ASI Output Parameters
Proceed as follows to set up the ASI Output parameters:
1 From the user interface of the D9804 MTR, click the Setup tab, and then click the
1 From the user interface of the D9804 MTR, click the Setup tab, and then click the
ASI-1 to ASI-6 for each of the outputs.
2 Select the Output Enabled. It indicates the status of the output.
Choose Yes to enable the output or No to disable the output. The default is No.
3 Set the Inband Data. It determines whether to use inband data or local data for
output routing.
Select Ignore to not use the inband data updates for the Source, CT PID and BISS
Index.
Select Apply to use the Source, CT PID, and BISS Index selected by the inband
data for the chosen CT ID.
Select Ignore to not use the inband data updates for the Source, CT PID and BISS
Index.
Select Apply to use the Source, CT PID, and BISS Index selected by the inband
data for the chosen CT ID.
4 Set the RF input stream (Input Source) for the selected output.
You may select RF1 to RF4, or ASI.
5 Select the output stream Format for the selected output.
Choose Raw if you want the incoming stream to pass to the output as is, with no
changes.
Choose Pass if you want only the PIDs in the Filter Info table to pass to the
output.
Choose Drop if you want all the PIDs, except for those selected, to be dropped to
pass to the output.
Select Decombine if you want only the selected CT PID to be decombined to
pass to the output.
changes.
Choose Pass if you want only the PIDs in the Filter Info table to pass to the
output.
Choose Drop if you want all the PIDs, except for those selected, to be dropped to
pass to the output.
Select Decombine if you want only the selected CT PID to be decombined to
pass to the output.